Batch deburr small parts and eliminate time-consuming hand deburring Send us your parts for complimentary testing

Applications
• medical parts – swiss turned
• drilled or threaded parts
• machined or stamped parts

Benefits
• costs less than hand deburring
• deburr parts faster & better
• improve quality of parts

Hand Deburring Small Parts
A) Time Consuming Hand deburring is a labor intensive process
B) Production Bottleneck Hand deburring puts a limit on your productivity
C) Expensive Hand deburring requires costly manual labor

Batch Deburring Small Parts
A) Deburr Faster & Better Improve part quality and get more consistent results
B) Speed Up Production Batch deburr dozens, hundreds, or thousands of parts in minutes
C) Reduce Cost-per-part Eliminate expensive hand deburring costs

Spinner Machine Includes:

• sPINner pin media and deburring container
• Deburring solution and media separating sieve
• Operation manual

Choose the sPINner machine that fits your needs. Typical deburring cycles are only 15-20 minutes, and all sPINner machines allow variable intensity and duration of deburring cycles using the programmable control panel.

You can also increase or decrease the deburring action by changing the diameter and length of media. Choose the size required for your part from the table on the next page.

For high-volume, continuious cycle deburring we recommend EDH-SFS200 filtration system. (left)

 Media

Vibratory Parts & Media Separator

 • Quickly separates parts from media

 • Speeds production

High-Capacity Parts & Media Separator

• Magnetic attraction separates media
from parts—FAST!

• Handles large batches of parts easily

sPINner Stainless Steel Pin Media

Our special stainless steel media is the reason the sPINner can deburr where other media is ineffective. Each SUS 304 stainless steel pin is hardened to HRC 30 and features a magnetic treatment to enhance deburring action.

To deburr hard materials like stainless steel, steel, etc., use a diameter of media bigger than 0.5mm. Use sizes less than 0.5mm for soft material like brass, copper, aluminum, gold, etc. If you want to deburr small holes, choose a diameter of pin media that is smaller than the hole. 3mm length media will work better for small holes and crevices. Choose larger pins for harder material or to increase the deburring action on stubborn burrs.

PFS-747 Deburring Solution

It is important to use the proper mix of deburring solution to facillitate part deburring and cleaning parts. Use PFS-747 with all sizes of sPINner media. Dilute to a 50:1 ratio with water.